Skip to content

Supplies Network

Print Tracker currently supports integrating with Supplies Network for automatic supply auto-fulfillment. All auto-fulfillment configuration is managed through Supplies Network, Print Tracker only allows you to either enable or disable the integration. When enabled, meter reads are sent to Supplies Network daily for predictive analysis.

Who are you?

Dealer

Dealers that are setting up a Supplies Network integration for the first time should reach out to Supplies Network and Print Tracker to setup the integration for their dealership.

Anyone else

Assuming that a Supplies Network integration has already been setup by your dealer, you can enable this integration at any entity or even for specific devices.

Enabling Auto-fulfillment

For an Entity

If you want to enable Supplies Network for an entity and all of its children, then

  1. Navigate to the entity using the entity selector
  2. Using the sidebar, click Admin > Manage entity
  3. Click the Settings tab
  4. Click Auto-fulfillment under the "Device default settings" section
  5. Set the Enabled toggle to the "on" position.

For a Device

If you want to enable or explicitly disable Supplies Network for a specific device, then

  1. Using the sidebar, click Device > View Devices to view your full device list
  2. Find the device you want to configure and click on it
  3. Click on the Settings tab
  4. Click Auto-fulfillment under the "Device settings" section
  5. Set the Enabled toggle to either "on" or "off".